Formation and emission characteristics of PMs in a 220MW coal-fired unit

XIA Yongjun; GUI Liangming; WU Ying; WANG Qian; LIU Fasheng; LI Haishan

English

您当前的位置：

首页 >

文章列表页 >

Formation and emission characteristics of PMs in a 220MW coal-fired unit

Thermal Power Generation Vol. 45, Issue 7, Pages: 27-31(2016)

更新时间：2025-09-28

- Formation and emission characteristics of PMs in a 220MW coal-fired unit
- 作者机构：
  
  国网江西省电力科学研究院
- 作者简介：
- 基金信息：
- DOI：
  CLC： X773
- Published：2016
- 稿件说明：
移动端阅览
XIA Yongjun, GUI Liangming, WU Ying, et al. Formation and emission characteristics of PMs in a 220MW coal-fired unit[J]. Thermal Power Generation, 2016, 45(7): 27-31.
DOI：

XIA Yongjun, GUI Liangming, WU Ying, et al. Formation and emission characteristics of PMs in a 220MW coal-fired unit[J]. Thermal Power Generation, 2016, 45(7): 27-31. DOI：

摘要

利用低压撞击器系统对某200 MW燃煤发电机组布袋除尘器入口和出口及石灰石-石膏湿法脱硫(WFGD)塔出口的颗粒物进行现场采样

分析了机组的颗粒物粒径分布情况、布袋除尘器的除尘特性

以及WFGD系统对颗粒物排放特性的影响。结果表明:煤粉燃烧生成的颗粒物呈明显的双模态粒径分布

超细颗粒物PM0.2在PM10中占比重较小

仅为0.64%;布袋除尘器对PM10颗粒物的脱除效率为99.98%

但对超细颗粒物PM0.2的脱除效率偏低

约为99.88%

这是由于布袋除尘器工作过程中小粒径颗粒更易穿透布袋及其表面的灰层;WFGD系统对粒径超过2.5μm的颗粒物具有脱除作用

但在WFGD系统运行中由于石膏浆液携带以及超细颗粒物的团聚长大

会使粒径在0.5μm左右的颗粒物质量浓度大幅增加。

Abstract

By applying low-pressure impactor system

particulate matter(PM)measurements were performed at the inlet and outlet of the fabric filter(FF)and the outlet of limestone-gypsum wet flue gas desulfurization(WFGD)tower in a 220 MW pulverized coal fired power plant unit.The PM formation characteristics

the FF's dust removal characteristics and the influence of the WFGD system on PM emission were discussed.The results show that

the PMs were of bimodal size distribution and the PM0.2accounted for only 0.64% of the PM10.The FF had a high removal efficiency(99.98%)to the total fly ash particles.However

the removal efficiency of PM0.2 was only 99.88%

as the PMs with smaller particle size penetrate the filter and deposited on the surface more easily.The concentration of PMs with diameter larger than 2.5μm reduced in the WFGD system while the PMs with diameter less than 2.5μm(particularly around 0.5μm)increased due to the ultrafine PM aggregation as well as new PM formation from gypsum slurry entrainment.

关键词

Keywords

references

Views

104

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Formation and emission characteristics of PMs in a 220 MW coal-fired unit

Operation performance of electrostatic precipitator in circulating fluidized bed boiler in wide load range

Pollutants reduction characteristics of brown coal-fired units during water recovery from flue gas

Synergistic removal technologies for flue gas pollutants and their engineering applications in coal-fired units

Current status and development of control technologies for PM2.5 and Hg during pulverized coal combustion

Related Author

WU Ying

GUI Liangming

XIA Yongjun

WANG Qian

LIU Fasheng

LI Haishan

YAN Keping

ZHENG Qinzhen

Related Institution

College of Chemical and Biological Engineering, Zhejiang University

Shangdu Power Plant, Northern United Power Co., Ltd., Xilin Hot

Xi’an Thermal Power Research Institute Co., Ltd.

Huaneng Tongchuan Zhaojin Power Plant

State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology

AI问答

⁰