Precision correction for surface heat transfer coefficient of a steam turbine rotor

LIU Shi; ZHOU Yan; ZHANG Hengliang; XIE Danmei

English

您当前的位置：

首页 >

文章列表页 >

Precision correction for surface heat transfer coefficient of a steam turbine rotor

Thermal Power Generation Vol. 43, Issue 7, Pages: 143-145(2014)

更新时间：2025-09-28

- Precision correction for surface heat transfer coefficient of a steam turbine rotor
- 作者机构：
  
  1. 广东电网公司电力科学研究院
  2. 武汉大学动力与机械学院
- 作者简介：
- 基金信息：
- DOI：
  CLC： TK263.61
- Published：2014
- 稿件说明：
移动端阅览
LIU Shi, ZHOU Yan, ZHANG Hengliang, et al. Precision correction for surface heat transfer coefficient of a steam turbine rotor[J]. Thermal Power Generation, 2014, 43(7): 143-145.
DOI：

LIU Shi, ZHOU Yan, ZHANG Hengliang, et al. Precision correction for surface heat transfer coefficient of a steam turbine rotor[J]. Thermal Power Generation, 2014, 43(7): 143-145. DOI：

摘要

以某亚临界300MW机组汽轮机转子为例

将基于CFDFluent软件采用耦合数值计算的转子换热系数作为理论值

与采用西屋及前苏联经验公式的计算结果进行比较

提出了基于西屋公式的汽轮机转子表面换热系数修正公式。利用该公式对亚临界300MW机组和超临界600MW机组汽轮机转子表面换热系数进行修正。研究结果表明:西屋及前苏联经验公式的计算结果与理论值的相对误差较大

且前苏联公式计算结果偏差更明显;按照本文修正公式对西屋公式的计算结果进行修正后

与理论值的相对误差降至2.4%~27%;对于同一转子可采用相同的修正系数

且能保证较快的计算速度。

Abstract

Taking the rotor of steam turbine in a subcritical 300MW unit as the object

the surface heat transfer coefficients of the rotor calculated by Westinghouse and former Soviet empirical formula were compared with that obtained by coupling numerical method

which was regarded as the theoretical value in this paper

on the basis of the CFD Fluent software.Moreover

correction formula for surface heat transfer coefficient of the rotor obtained by the Westinghouse empirical formula was proposed and applied in a supercritical 600MW unit.The results show that

the relative error between the Westinghouse(former Soviet)formula result and the theoretical value is large

and the error between the former Sovient formula result and the theoretical value is more obvious.After using the proposed correction formula to modify the Westinghouse formula result

the relative error of the rotor surface heat transfer coefficient between the modified value and the theoretical value dropped to 2.4%-27%.A correction coefficient can be applied to the same rotor

and the calculation speed can be ensured.

关键词

Keywords

references

Views

243

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Heat transfer coefficient calculation for external heat exchanger in CFB boilers

Influence of head wind velocity distribution on heat transfer performance of ACC single-row finned tubes

Effects of attack angle and endwall slippage on flow and heat transfer of blade squealer tip

Research progress of heat transfer enhancement in two-phase closed gravity heat pipe

Correction calculation of surface heat transfer coefficient of high pressure cylinder for nuclear power turbines

Related Author

CHEN Xincan

CAI Aimin

WANG Yifeng

WANG Zhiwei

YE Sheng

YANG Jianguo

DAI Shanliang

KOU Zhihai

Related Institution

Xi'an Thermal Power Research Institute Co., Ltd

School of Energy and Power Engineering, Xi'an Jiaotong University

China Power Investment Corporation Jiangxi Branch

Huaxi Energy Industry Group Co., Ltd

Institute of Energy and Environment, Harbin Institute of Technology

AI问答

⁰