Fault analysis and treatment for shaft system vibration of a 1000 MW unit during its debugging period

WANG Yanbo1; ZHANG Weijiang2; YANG Qing1 1.Xi'an Thermal Power Research Institute Co.Ltd.

English

您当前的位置：

首页 >

文章列表页 >

Fault analysis and treatment for shaft system vibration of a 1000 MW unit during its debugging period

Thermal Power Generation Vol. 42, Issue 2, Pages: 89-91(2013)

更新时间：2025-09-28

- Fault analysis and treatment for shaft system vibration of a 1000 MW unit during its debugging period
- 作者机构：
  
  1. 西安热工研究院有限公司
  2. 华能海门电厂
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621
- Published：2013
- 稿件说明：
移动端阅览
WANG Yanbo1, ZHANG Weijiang2, YANG Qing1 1.Xi'an Thermal Power Research Institute Co.Ltd.. Fault analysis and treatment for shaft system vibration of a 1000 MW unit during its debugging period[J]. Thermal Power Generation, 2013, 42(2): 89-91.
DOI：

WANG Yanbo1, ZHANG Weijiang2, YANG Qing1 1.Xi'an Thermal Power Research Institute Co.Ltd.. Fault analysis and treatment for shaft system vibration of a 1000 MW unit during its debugging period[J]. Thermal Power Generation, 2013, 42(2): 89-91. DOI：

摘要

对华能海门电厂3号超超临界1 000MW机组轴系在调试期间发生的振动故障进行了分析处理。该机组在高速暖机过程中高压转子发生动静碰摩故障

经连续盘车2h后

故障消除;在首次带大负荷过程中因轴封蒸汽温度比正常值偏低约20℃导致B低压转子发生动静碰摩故障

通过提高轴封蒸汽温度使其维持正常温度范围后

振动故障消除;额定负荷工况下

7Y、9Y和10Y测点轴振振幅分别处于报警值

通过对B低压转子和发电机转子进行现场高速动平衡后

机组轴系振动处于优良水平。

Abstract

For the No.3 supercritical 1 000 MW unit in Huaneng Haimen Power Plant

its high pressure rotor had a rotor friction between dynamic and static parts during high speed warm-up period

after continuous turning gear for 2 hours

the fault was eliminated.Because the shaft sealing steam temperature was about 20 ℃ lower than the normal value when the turbine ran under large load for the first time

the low pressure B rotor had the same fault

and the vibration was eliminated through improving the shaft sealing steam temperature and keeping it at the normal level.Under rated load condition

the shaft vibration amplitudes of measuring point 7Y

and 10Y reached the alarm value

respectively

through conducting field high speed dynamic balancing for the low pressure B rotor and the generator rotor

the shaft vibration returned to the normal level.

关键词

Keywords

references

Views

171

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

DIAGNOSIS AND REMEDY OF THE VIBRATION FAULT FOR ULTRA-SUPERCRITICAL 1000 MW UNIT

FAULT DIAGNOSIS AND DISPOSAL OF VIBRATION ON 1036 MW UNIT NO.2 IN HUANENG HAIMEN POWER PLANT

STUDY ON PRACTICAL PROGRAM OF THE INFLUENCE COEFFICIENT METHOD FOR ROTOR DYNAMIC BALANCING

NOISE CONTROL OF DIESEL GENERATOR SETS

CAUSE ANALYSIS OF FURNACE WALL VIBRATION FOR UTILITY BOILERS

Related Author

ZHANG Weijun1

CHEN Shengjun2

ZHANG Xueyan1

GE Xiang1

HE Guo'an1

YU Huawen2

LEI Peng2 1.Xi'an Thermal Power Research Institute Co Ltd

ZHANG Weijiang2 1.Xi'an Thermal Power Research Institute Co Ltd

Related Institution

Huaneng Yuhuan Power Plant

Beijing Beizhong Steam Turbine Motor Co., Ltd

Zhenjiang Shipbuilding Institute

Zhenjiang Shipyard College

AI问答

⁰