CALCULATION METHOD OF pH VALUE IN BOILER WATER UNDER LOW PHOSPHATE TREATMENT MODE AND APPLICATION THEREOF

English

您当前的位置：

首页 >

文章列表页 >

CALCULATION METHOD OF pH VALUE IN BOILER WATER UNDER LOW PHOSPHATE TREATMENT MODE AND APPLICATION THEREOF

Thermal Power Generation Vol. 40, Issue 9, Pages: 34-37(2011)

更新时间：2025-09-28

- CALCULATION METHOD OF pH VALUE IN BOILER WATER UNDER LOW PHOSPHATE TREATMENT MODE AND APPLICATION THEREOF
- 作者机构：
  
  1. 西安热工研究院有限公司
  2. 广州珠江电厂
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621.2
- Published：2011
- 稿件说明：
移动端阅览
ZHANG Weike1, SUN Benda1, LOU Yihong2 1.Xi'an Thermal Power Research Institute Co Ltd. CALCULATION METHOD OF pH VALUE IN BOILER WATER UNDER LOW PHOSPHATE TREATMENT MODE AND APPLICATION THEREOF[J]. Thermal Power Generation, 2011, 40(9): 34-37.
DOI：

ZHANG Weike1, SUN Benda1, LOU Yihong2 1.Xi'an Thermal Power Research Institute Co Ltd. CALCULATION METHOD OF pH VALUE IN BOILER WATER UNDER LOW PHOSPHATE TREATMENT MODE AND APPLICATION THEREOF[J]. Thermal Power Generation, 2011, 40(9): 34-37. DOI：

摘要

对炉水中各种碱化剂(NH3、Na3PO4和NaOH)对炉水pH值的影响进行分析

给出了低磷酸盐处理方式下炉水pH值的计算方法

并给出不同炉水处理体系炉水pH值与炉水PO43-含量的关系曲线及典型应用。研究结果表明:(1)在炉水pH值计算时

如果PO43-小于2 mg/L

则可以将Na3PO4当作一元强碱来处理;(2)在炉水NaOH和Na3PO4含量较低的情况下

炉水中氨对pH值的作用显著;(3)将现有的水汽品质在线监测数据如给水电导率、炉水PO43-浓度以及配药时NaOH与Na3PO4.12H2O的比例代入炉水pH值计算公式即可方便地计算出炉水pH值

从而有效指导炉水pH值的控制和判断炉水pH值测量的准确性;(4)不同炉水处理体系的关系曲线有助于合理选择炉水处理方式。

Abstract

The influence of different alkalization agents

i.e.NH3

Na3PO4

and NaOH

in boiler water upon the pH value of boiler water has been analysed

the calculation method for pH value of boiler water under low phosphate treatment mode being given

and the relationship curves between pH value of boiler water and the PO3-4 content in boiler water in different boiler water treatment systems and their typical application being also given.Results of study show that as listed in the following:(1) during the time of calculating the pH value of boiler water

if PO3-4 is less than 2 mg/L

the Na3PO4 can be handled as one-dimentional strong alkaline;(2) under condition of NaOH and Na3PO4 content inboiler water is lower

the effect of ammonia in boiler water upon the pH value is remarkable;(3) the existing on-line monitoring data of steam-water quality

such as feed-water conductivity

PO3-4 in boiler water

as well as proportioning ratio of NaOH and Na3PO4·12H2O in making up the dosage can be substituded into the calculation formula of pH value in boiler water

the pH value of boiler water can be conveniently calculated out

giving effective guidance to pH value control of boiler water

and can judge the accuracy of pH value measurement for boiler water;(4) the relationship curves in defferent boiler water treatment systems are useful to select the suitable boiler water treatment mode.

关键词

Keywords

references

0

Views

183

下载量

4

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Related Articles

An on-line measurement method of trace chlorine ion and its application in power plants

Layout and optimization of a new-type connecting flue with side-inlet and side-outlet for SCR denitrification systems

Experimental analysis on factors affecting selective non-catalytic reduction flue gas denitration

A STUDY ON CALCULATION METHOD CONCERNING THE BLOWDOWN RATE OF BOILERS

STUDY ON A NEW TYPE CATALYST USED FOR SELECTIVE CATALYTIC REDUCTION OF NO_x WITH NH₃ UNDER LOW TEMPERATURE

Related Author

SHEN Xiaoxiang

PAN Zhenbo

TIAN Li

DAI Xin

DONG Chen

CHANG Lei

ZHANG Guangjie

REN Rui

Related Institution

Xi'an Thermal Power Research Institute Co.,Ltd.

Sanmenxia Huayang Power Generation Co.,Ltd.

Xi’an Thermal Power Research Institute Co., Ltd.

Xi’an Thermal Environmental Engineering Co., Ltd.

Key Laboratory of Condition Monitoring and Control for Power Plant Equipment, North China Electric Power University

AI问答

⁰