THE FORMATION MECHANISM OF AMMONIUM BISULFATE IN SCR FLUE GAS DENITRIFICATION PROCESS AND CONTROL THEREOF

MA Shuangchen; JIN Xin; SUN Yunxue; CUI Jiwei College of Environmental Science and Engineering

English

您当前的位置：

首页 >

文章列表页 >

THE FORMATION MECHANISM OF AMMONIUM BISULFATE IN SCR FLUE GAS DENITRIFICATION PROCESS AND CONTROL THEREOF

Thermal Power Generation Vol. 39, Issue 8, Pages: 12-17(2010)

更新时间：2025-09-28

- THE FORMATION MECHANISM OF AMMONIUM BISULFATE IN SCR FLUE GAS DENITRIFICATION PROCESS AND CONTROL THEREOF
- 作者机构：
  
  华北电力大学环境科学与工程学院
- 作者简介：
- 基金信息：
- DOI：
  CLC： X701
- Published：2010
- 稿件说明：
移动端阅览
MA Shuangchen, JIN Xin, SUN Yunxue, et al. THE FORMATION MECHANISM OF AMMONIUM BISULFATE IN SCR FLUE GAS DENITRIFICATION PROCESS AND CONTROL THEREOF[J]. Thermal Power Generation, 2010, 39(8): 12-17.
DOI：

MA Shuangchen, JIN Xin, SUN Yunxue, et al. THE FORMATION MECHANISM OF AMMONIUM BISULFATE IN SCR FLUE GAS DENITRIFICATION PROCESS AND CONTROL THEREOF[J]. Thermal Power Generation, 2010, 39(8): 12-17. DOI：

摘要

简述选择性催化还原(SCR)烟气脱硝原理。指出SCR脱硝过程出现硫酸氢铵的危害

详细分析了硫酸氢铵形成的影响因素

如NH3/NOx摩尔比、SO3浓度、硫酸氢铵的露点温度等。根据硫酸氢铵的特性提出了控制硫酸氢铵生成的方法与减少其负面影响的措施:通过控制SCR脱硝过程氨逃逸量和烟气中SO2氧化率的方法减少硫酸氢铵的生成量;为防止催化剂因硫酸氢铵的滞留而失去活性

合理控制SCR脱硝装置在低负荷下的运行时间;为有效降低硫酸氢铵在空气预热器(空预器)换热元件上的形成速率

选用搪瓷镀层换热元件。

Abstract

The principle of selective catalystic reduction(SCR) denitrification process has been briefly expounded

pointing out the harmfulness of ammonium bisulfate(ABS) occurred in SCR denitrification process.The main affecting factors for ABS formation

such as the mole ratio of NH3/NOx

the SO3 concetration

and the dew point of ABS etc.

have been analysed in detail.According to the properties of ABS

the measures for controlling formation of ABS and recducing negative impacts of ABS have been put forward:through controlling the amount of ammonia escape in the SCR process and the oxidation rate of SO2 in the flue gas

the formation amount of ABS is to be reduced;in order to prevent the catalyst to lose its activity due to hold-up of ABS

the operating time of SCR under low load has to be reasonably controlled;for effectively decreasing the formation rate of ABS on heat-exchanging elements in the preheater

the ceramic coating has to be selected for said elements.

关键词

Keywords

references

Views

3682

下载量

344

CSCD

Alert me when the article has been cited

提交

Publicity Resources

FLUE GAS DENTTRIFICATION TECHNOLOGIES AND ANALYSIS OF THEIR CHEMICAL REACTONS

Research and application of data-based optimization technology for operation of denitrification system in utility boilers

Model for predicting SCR flue gas denitration efficiency based on particle swarm optimization and twin support vector machine

Design of flue gas denitration control system based on feedforward constrained dynamic matrix control

Related Author

吴碧君

王述刚

方志星

盛永校

姜龙

李金晶

姚宣

黄中

Related Institution

Nanjing University of Technology

Zhejiang Energy Group Co., Ltd

Focused Photonics (Hangzhou) Inc.

School of Information Science and Technology, Zhejiang Sci-Tech University

Xi’an Thermal Power Research Institute Co., Ltd.

AI问答

⁰