AN APPROACH TO CONTROL INDEX OF Cu AND Fe CONTENT IN CIRCULATING WATER OF THERMAL POWER PLANTS

HUANG Shanfeng1; LUO Jianghe1; REN Zhigang2; JIAO Huiliang3; ZHANG Baoshan31.Xi'an Thermal Power Research Institute Co Ltd

English

您当前的位置：

首页 >

文章列表页 >

AN APPROACH TO CONTROL INDEX OF Cu AND Fe CONTENT IN CIRCULATING WATER OF THERMAL POWER PLANTS

Thermal Power Generation Vol. 39, Issue 4, Pages: 17-22(2010)

更新时间：2025-09-28

- AN APPROACH TO CONTROL INDEX OF Cu AND Fe CONTENT IN CIRCULATING WATER OF THERMAL POWER PLANTS
- 作者机构：
  
  1. 西安热工研究院有限公司
  2. 西安市特种设备检验检测院
  3. 华能上安电厂
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621.8
- Published：2010
- 稿件说明：
移动端阅览
HUANG Shanfeng1, LUO Jianghe1, REN Zhigang2, et al. AN APPROACH TO CONTROL INDEX OF Cu AND Fe CONTENT IN CIRCULATING WATER OF THERMAL POWER PLANTS[J]. Thermal Power Generation, 2010, 39(4): 17-22.
DOI：

HUANG Shanfeng1, LUO Jianghe1, REN Zhigang2, et al. AN APPROACH TO CONTROL INDEX OF Cu AND Fe CONTENT IN CIRCULATING WATER OF THERMAL POWER PLANTS[J]. Thermal Power Generation, 2010, 39(4): 17-22. DOI：

摘要

分析了循环水中Cu、Fe存在的形式和特点

提出了通过动态模拟试验求得铜、铁金属腐蚀速率

从而确定循环水Cu、Fe含量控制指标的方法。理论计算和现场测定表明:(1)循环水中溶解态Fe含量很低

系统中铁金属腐蚀产物或硫酸亚铁保护膜(保护膜)溶解产物多以不溶解的化合物形式存在

因此循环水中Fe含量对循环水系统中铁金属腐蚀或保护膜溶解速率的反映不明显;(2)通过循环水取样测得的Cu绝大多数为溶解态Cu

铜材质的腐蚀产物主要溶解在循环水中

所以循环水中铜腐蚀产物未达到溶解平衡时

循环水的Cu含量在一定程度上可反映铜材腐蚀速率和保护膜的好坏。

Abstract

The forms and features of existing Cu and Fe in circulating water have been analysed

and a method for determining the control index of Cu and Fe content in circulating water through metal corrosion rate of Cu and Fe obtained from dynamic simulation test being put forward.The theoritical calculation and measurement in the field show that:(1) the reflection of corrosion rate of carbon steel by using Fe content in circulation water isn't obvious due to the solubility of iron corrosion products and protective film of iron sulfate in the circulating water system is too low;(2) the reflection of corrosion rate of copper by using Cu content in circulating water is obvious due to corrosion products of copper are mainly dissolved in circulating water

hence

under condition of copper corrosion products in circulating water isn't reaching dissolution balance

the Cu content in circulating water can in certain degreereflect the corrosion rate of copper and the state of protective film.

关键词

Keywords

references

Views

105

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

PROBLEMS EXISTING IN OPERATION OF WET LIMESTONE/GYPSUM DESULFURATION SYSTEM IN LUOHUANG POWER PLANT AND ANALYSIS THEREOF

CAUSE ANALYSIS OF CORROSION FOR CHEMICAL-DOSING TUBE ENTERING INTO THE DRUM PORT

CAUSE ANALYSIS AND PROTECTIVE MEASURES FOR CORROSIVE PERFORATION OF CONDENSER’S COPPER TUBES IN YUNFU POWER PLANT

CAUSE ANALYSIS OF FREQUENT BURST-LEAKAGE OCCURRED ON REHEATER AND WATER-WALL OF 300 MW UTILITY BOILER

CAUSE ANALYSIS ABOUT LEAKAGE OF "FOUR TUBE KINDS" IN BOILERS

Related Author

CHEN Shao min

ZHANG Cuihong

LI Lin

WANG Jiu-zhen

YIN Gang (Xi’an Jiaotong University

AN Lian-suo1

TONG Peng1

JIANG Gen-shan1

Related Institution

Chongqing Electric Power College Chongqing

Shengli Power Plant Dongying

Yunfu Power Plant Guangdong Yunfu

Yunfu Power Plant

AI问答

⁰