HEAT TRANSFER CALCULATION FOR EVAPORATIVE HEATING SURFACE IN SUPERCRITICAL ONCE-THROUGH BOILER SUITABLE FOR PREDICTION OF ENTHALPY VALUE AT INTERMEDIATE POINT

LIU Fu-guo; HAN Xiao-gang; HOU Fan-jun; ZHAO Xiao-qiaoShandong Electric Power Research Institute

English

您当前的位置：

首页 >

文章列表页 >

HEAT TRANSFER CALCULATION FOR EVAPORATIVE HEATING SURFACE IN SUPERCRITICAL ONCE-THROUGH BOILER SUITABLE FOR PREDICTION OF ENTHALPY VALUE AT INTERMEDIATE POINT

Thermal Power Generation Vol. 38, Issue 11, Pages: 47-52(2009)

更新时间：2025-09-28

- HEAT TRANSFER CALCULATION FOR EVAPORATIVE HEATING SURFACE IN SUPERCRITICAL ONCE-THROUGH BOILER SUITABLE FOR PREDICTION OF ENTHALPY VALUE AT INTERMEDIATE POINT
- 作者机构：
  
  山东电力研究院
- 作者简介：
- 基金信息：
- DOI：
  CLC： TK229.2
- Published：2009
- 稿件说明：
移动端阅览
LIU Fu-guo, HAN Xiao-gang, HOU Fan-jun, et al. HEAT TRANSFER CALCULATION FOR EVAPORATIVE HEATING SURFACE IN SUPERCRITICAL ONCE-THROUGH BOILER SUITABLE FOR PREDICTION OF ENTHALPY VALUE AT INTERMEDIATE POINT[J]. Thermal Power Generation, 2009, 38(11): 47-52.
DOI：

LIU Fu-guo, HAN Xiao-gang, HOU Fan-jun, et al. HEAT TRANSFER CALCULATION FOR EVAPORATIVE HEATING SURFACE IN SUPERCRITICAL ONCE-THROUGH BOILER SUITABLE FOR PREDICTION OF ENTHALPY VALUE AT INTERMEDIATE POINT[J]. Thermal Power Generation, 2009, 38(11): 47-52. DOI：

摘要

给出了基于超临界直流锅炉蒸发受热面实际运行状态的传热建模方法。根据炉膛受热面运行特性确定其结构和污染状态参数

采用参数预测所获得的受热面吸热量

进而给出适合于中间点焓值预测的蒸发受热面传热计算模型

该模型可清晰地描述中间点焓值和各影响因素之间的定量关系。通过对超临界600 MW机组直流锅炉改变煤种、水煤比、负荷和过量空气系数的试验表明

该模型能够准确预测中间点焓值;当锅炉运行条件发生变化时该模型可用于修正热工过程调节参数

指导蒸汽温度调节。

Abstract

The heat transfer modelling method based on actual status of the evaporative heating surface for supercritical once-through boiler has been given.On the basis of operation characters concerning the heating surface

the structure of said heating surface and its parameters under polluted status have been determined

the absorbed heat of said heating surface being predicted by adopting the obtained parameters and the heat transfer calculation model of said evaporative heating surface suitable for prediction of enthalpy value at the intermediate point being further given.This model can clearly describe quantitative relationship between the enthalpy value at intermediate point and every affecting factor.Through test of varying the coal sort

the proportioning ratio of water and coal

the load

and the coefficient of excess air of the once-through boiler for supercritical 600 MW unit

it is shown that the said model can accurately predict the enthalpy value at intermediate point;in the event of variation in operation condition of the boiler

the said model can be used to correct the thermodynamic adjusting parameters

guiding the adjustment of steam temperature.

关键词

Keywords

references

Views

238

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Fuzzy control system for intermediate point enthalpy based on feedforward of feed-water temperature

Simulation modelling of power system for supercritical units considering dynamic heat exchange of once-through boiler

Dynamic simulation for absorbed heat of super-heater in supercritical unit boilers

DEBUGGING AND RETROFITTING OF THERMAL CONTROL SYSTEM FOR 600 MW SUPERCRITICAL UNITS IN HUANENG QINBEI POWER PLANT

PIPE BLOWING OF SUPERCRITICAL ONCE-THROUGH BOILER FOR 600MW UNIT BY USING SINGLE-STAGE PRESSURE-REDUCING METHOD

Related Author

YANG Zihao

ZHANG Yanping

GAO Wei

徐达睿

郝玲

陈磊

祁鑫

刘一峰

Related Institution

School of Energy and Power Engineering, Huazhong University of Science and Technology

Thermal Engineering Research Center,North China University of Water Resources and Electric Power

Huaneng Qinbei Power Plant

Xi'an Thermal Power Research Institute Co., Ltd

Guodian Fuzhou Power Generation Co., Ltd

AI问答

⁰