Analysis on start-up and commissioning of supercritical 660 MW steam turbine

WU Shougui; LIU Jifeng; ZHANG Chen; GAO Kui; WANG Xinyang

doi:10.19666/j.rlfd.201709104

English

您当前的位置：

首页 >

文章列表页 >

Analysis on start-up and commissioning of supercritical 660 MW steam turbine

Thermal Power Generation Vol. 47, Issue 4, Pages: 99-103(2018)

更新时间：2025-09-28

- Analysis on start-up and commissioning of supercritical 660 MW steam turbine
- 作者机构：
  
  西安热工研究院有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.201709104
  CLC： TK26
- Published Online：09 April 2018，
  
  Published：2018
- 稿件说明：
移动端阅览
WU Shougui, LIU Jifeng, ZHANG Chen, et al. Analysis on start-up and commissioning of supercritical 660 MW steam turbine[J]. Thermal Power Generation, 2018, 47(4): 99-103.
DOI：

WU Shougui, LIU Jifeng, ZHANG Chen, et al. Analysis on start-up and commissioning of supercritical 660 MW steam turbine[J]. Thermal Power Generation, 2018, 47(4): 99-103. DOI： 10.19666/j.rlfd.201709104.

摘要

针对某超临界660 MW机组汽轮机启动调试过程中出现低速暖机时间长、带初负荷过程负荷和再热蒸汽压力异常波动、再热器多次保护动作导致机组跳闸事故等重大问题

分析并阐明启动参数低、X7准则定值高、高中压调节阀开度比例不匹配、分布式控制系统与汽轮机数字电液控制系统控制逻辑不完善是存在问题的主要原因。通过启动参数调整、X7准则优化、控制策略优化以及逻辑深度排查

并针对问题提出有效的防范措施后

再次启动顺利完成汽轮机空负荷试运

带负荷试运以及一次性通过168 h满负荷连续试运

可为同类型新建机组的汽轮机启动调试提供借鉴。

Abstract

During the start-up and commissioning process of a supercritical 660 MW unit steam turbine

the lowspeed warm-up time was over long

the load and reheat steam pressure in the initial load process fluctuated abnormally

and multiple protection actions of the reheater caused several serious accidents like tripping.Investigation on these problems shows that

low start-up parameter

high setting value of X7 criterion

dismatch of the high and medium pressure regulating valve opening ratio

and imperfection of the control logic in distributed control system(DCS) and turbine digital electro-hydraulic control system(DEH) were main reasons for the above problems.Through parameter adjustment

X7 standard optimization

control strategy optimization and logic depth investigation

effective preventive measures for the problems were put forward.After start again

the turbine empty load test

loading test and one-time through 168 hours full load continuous trial operation were all successfully completed.The research can provide experience and reference for start-up and commissioning of the same type of steam turbine in newly built power plants.

关键词

Keywords

references

Views

111

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

IMPROVEMENT OF PROTECTION CONTROL SYSTEM FOR STEAM TURBINE OF LARGE-CAPACITY THERMAL POWER UNITS

DESIGN OF CONTROL LOGIC FOR PUTTING TWO STEAM-DRIVEN FEED-WATER PUMPS OF SUPERCRITICAL 660 MW UNIT INTO PARALLEL OPERATION OR STOPPING ONE FROM SERVICE

Automatic control logic optimization for feed-water in start-up period of a 600MW unit

Review of flow path retrofit of 600MW class supercritical steam turbines

SIMPLIFIED FINITEELEMENT CALCULATION MODEL OF TEMPERATURE FIELD FOR STEAM TURBINE ROTOR

Related Author

ZHOU Li1

YANG Peicheng2

CUI Meng1

YANG Yafei11.Henan Electric Power Research Institute

LI Tiecang1

QIN Zhiguo2

BAI Jingping2 1.Department of Power Engineering

XI Chengchao

Related Institution

Henan Electric Power Test and Research Institute

Henan Electric Power Construction and Debugging Institute

Department of Power Engineering, Shanxi Electric Power Vocational College

Datong Power Generation Co., Ltd

Huaneng Shanghai Shidongkou Second Power Plant

AI问答

⁰