Research and engineering practice for the effect of fly ash distribution on wear of flue gas cooler

NIU Guoping; ZHOU Mengwei; YANG Xiaogang; CHAO Yongshun; LI Haihao; JIA Guangrui; TAN Zengqiang

doi:10.19666/j.rlfd.202006185

English

您当前的位置：

首页 >

文章列表页 >

Research and engineering practice for the effect of fly ash distribution on wear of flue gas cooler

Thermal Power Generation Vol. 50, Issue 5, Pages: 139-146(2021)

更新时间：2025-09-28

- Research and engineering practice for the effect of fly ash distribution on wear of flue gas cooler
- 作者机构：
  
  1. 西安热工研究院有限公司
  2. 华能铜川照金煤电有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202006185
  CLC： TM621.2
- Published：2021
- 稿件说明：
移动端阅览
NIU Guoping, ZHOU Mengwei, YANG Xiaogang, et al. Research and engineering practice for the effect of fly ash distribution on wear of flue gas cooler[J]. Thermal Power Generation, 2021, 50(5): 139-146.
DOI：

NIU Guoping, ZHOU Mengwei, YANG Xiaogang, et al. Research and engineering practice for the effect of fly ash distribution on wear of flue gas cooler[J]. Thermal Power Generation, 2021, 50(5): 139-146. DOI： 10.19666/j.rlfd.202006185.

摘要

针对目前燃煤锅炉空气预热器出口烟道烟冷器换热管束的磨损问题

利用计算流体力学(CFD)软件进行气固两相流场模拟和磨损预测

研究分析飞灰分布对烟冷器的磨损影响

提出针对性的解决方案

并以国内某燃煤机组为例进行了改造前、后的数值模拟研究。结果表明:改造前、后

飞灰质量浓度相对标准偏差左侧由77.29%下降至43.22%

右侧由69.45%下降至47.32%;首排管磨损速度最大值由1.51×10~(–6) kg/(m~2·s)下降至6.98×10~(–7) kg/(m~2·s);飞灰分布与烟冷器磨损有着较大的相关性。

Abstract

In view of the wear problem of heat exchange tube bundle of the flue gas cooler at the outlet of air preheater of the coal-fired boiler at present

the computational fluid dynamics(CFD) software is used to simulate the gas-solid two-phase flow field and predict the wear. The influence of fly ash distribution on wear of the flue gas cooler is studied

and the corresponding solutions are put forward. Moreover

a coal-fired unit in China is taken as an example to carry out the numerical simulation before and after the reformation. The result shows that

before and after the reformation

the relative standard deviation of fly ash concentration on the left side decreased from 77.29% to 43.22% and that on the right side standard decreased from 69.45% to 47.32%. The maximum wear rate of the first row of pipes decreased from 1.51×10~(–6) kg/(m~2·s) to 6.98×10~(–7) kg/(m~2·s). There is a great correlation between the distribution of fly ash and the wear of flue gas cooler.

关键词

Keywords

references

Views

200

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Numerical simulation of fly ash erosion on bolier tail flue channel

Numerical simulation of inner abrasion in a selective catalytic reduction deNO_x device

Simulation of low NO_x emission optimization in swirl combustion boiler based on superfine pulverized coal reburning

Theoretical and numerical simulation on parallel-flow dehumidifying solution spray absorber

Numerical simulation on biomass gas re-burning in a 660 MW coal-fired boiler

Related Author

ZHOU Mengwei

NIU Guoping

JIA Guangrui

LUO Zhi

TAN Zengqiang

YANG Xiaogang

ZHONG Yafei

WEI Hongqi

Related Institution

School of Energy and Environment, Southeast University

School of Power and Mechanical Engineering, Wuhan University

Inner Mongolia Mengdian Huaneng Thermal Power Co., Ltd. Wuhai Power Plant

Xi'an Xire Boiler Environmental Protection Engineering Co., Ltd

College of Electric Power, North China University of Water Resources and Electric Power

AI问答

⁰