Overall performance analysis and boundary exploration of organic working medium radial turbine

TIAN Hua; ZHANG Kun; WANG Xuan; HUANG Guangdai

doi:10.19666/j.rlfd.202110196

English

您当前的位置：

首页 >

文章列表页 >

Overall performance analysis and boundary exploration of organic working medium radial turbine

Thermal Power Generation Vol. 51, Issue 4, Pages: 38-46(2022)

更新时间：2025-09-28

- Overall performance analysis and boundary exploration of organic working medium radial turbine
- 作者机构：
  
  天津大学内燃机燃烧学国家重点实验室
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202110196
  CLC： TK115
- Published：2022
- 稿件说明：
移动端阅览
TIAN Hua, ZHANG Kun, WANG Xuan, et al. Overall performance analysis and boundary exploration of organic working medium radial turbine[J]. Thermal Power Generation, 2022, 51(4): 38-46.
DOI：

TIAN Hua, ZHANG Kun, WANG Xuan, et al. Overall performance analysis and boundary exploration of organic working medium radial turbine[J]. Thermal Power Generation, 2022, 51(4): 38-46. DOI： 10.19666/j.rlfd.202110196.

摘要

向心透平膨胀机具有效率高、结构简单等优点，是有机朗肯循环系统的核心部件，其性能直接影响系统热功转化效率。在内燃机余热回收系统中，透平工作状态会受内燃机复杂多变的工况影响，分析其全工况性能、探索其工况边界特点十分必要。利用计算流体力学软件进行数值模拟，开展向心透平全工况性能分析。结果表明：设计工况下输出功率和效率分别为13.435 kW、79.31%；对于非设计工况，温度变化对透平性能的影响幅度较小；入口压力通过改变透平质量流量来影响输出功率，二者呈线性关系；当入口压力为50%设计值时，透平效率受转速影响变化剧烈，很难再稳定工作；转速对透平工作状态影响较大，在±40%内变化时效率在60%以上，峰值接近80%；当转速变化超过±50%时，效率大幅下降甚至迫近零点，此时透平不宜再运行。该研究结果可为内燃机余热回收系统向心透平设计及实际运行提供参考。

Abstract

Radial turbine is the core component of organic Rankine cycle(ORC) system with high efficiency and simple structure

its performance directly affects the heat-to-power conversion efficiency of the system. In the waste heat recovery(WHR) system of internal-combustion engine(ICE)

the working state of turbine is affected by the complex and changeable working conditions of the ICE

so it's necessary to analyze the overall performance of turbine and explore the characteristics of working conditions boundary. However

the previous work has focused on the performance research near the design conditions. The computational hydrodynamic software is used to carry out numerical simulation and performance analysis for centripetal turbine under full load condition. The result shows that

the output power and efficiency under design condition are 13.435 kW and 79.31%. For off-design conditions

the temperature variation has a small effect on turbine performance. The inlet pressure affects the output power by changing mass flow rate

and the relationship is linear

when the inlet pressure is 50% design value

the efficiency changes dramatically under the influence of rotation speed

it's hard to work steadily. The rotation speed has a great influence on the working state of turbine

when the speed changes in the range of ±40%

the efficiency is above 60% and the peak value is close to 80%. When the speed changes out of ±50%

the efficiency drops sharply or even approaches 0

at which condition the turbine is not suitable for operation. The results can provide reference for design and operation of ORC radial turbines.

关键词

Keywords

references

Views

160

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Low temperature waste heat utilization system for cooling towers' attachments

Experimental research on heat charging and discharging performance of heat pipe phase change energy storage system

Critical speed analysis for a radial inflow turbine rotor system

Performance analysis on heat and water recovery from flue gas of coal-fired boiler

Research advances on waste heat recovery technology of natural gas-fired flue gas

Related Author

LU Yanhong

ZHU Zhihui

MAO Fa

ZHANG Xuelai

DING Lei

XU Weiwen

XU Wenfang

MA Xinling

Related Institution

College of Mechatronics and Automation, Tianjin Vocational University

College of Mechanical Engineering, Hebei University of Technology

Shanghai Maritime University Merchant Marine College

School of Chemical Engineering and Energy, Zhengzhou University

China State Grid Corporation

AI问答

⁰