Boiler efficiency calculation method for heat loss outside the system boundary

WANG Hongwu; LIU Huan; YU Longwen; YANG Rongzu; MU Qiwei; ZHANG Ben; ZHAI Pengcheng; XIE Tian; MA Tingshan

doi:10.19666/j.rlfd.202303047

English

您当前的位置：

首页 >

文章列表页 >

Boiler efficiency calculation method for heat loss outside the system boundary

Thermal Power Generation Vol. 52, Issue 12, Pages: 140-146(2023)

更新时间：2025-09-28

- Boiler efficiency calculation method for heat loss outside the system boundary
- 作者机构：
  
  1. 西安热工研究院有限公司
  2. 西安西热节能技术有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202303047
  CLC： TM621.2
- Published：2023
- 稿件说明：
移动端阅览
WANG Hongwu, LIU Huan, YU Longwen, et al. Boiler efficiency calculation method for heat loss outside the system boundary[J]. Thermal Power Generation, 2023, 52(12): 140-146.
DOI：

WANG Hongwu, LIU Huan, YU Longwen, et al. Boiler efficiency calculation method for heat loss outside the system boundary[J]. Thermal Power Generation, 2023, 52(12): 140-146. DOI： 10.19666/j.rlfd.202303047.

摘要

对用于系统边界外设备的热量进行分析，能量转换位置在GB/T 10184中的锅炉边界外，不能利用现有标准进行锅炉效率计算。将热风外用损失热量分为热风回用和热风不回用2类，基于GB/T 10184的计算框架，提出这2类热风外用损失的计算方法。以某350 MW机组锅炉作为实际算例，在相同负荷下连续进行投运热风外用和停运热风外用2个对比工况。依据实际测试数据和化验结果，利用该计算方法对实际运行工况进行对比，定量分析热风外用对锅炉效率的影响。计算结果表明：2个工况燃用煤质、飞灰、炉渣可燃物化验结果基本相当；冷风回收的工况T01热风外用损失为0.82%，冷风不回收的热风外用损失为0.13%，工况T02热风外用损失为0；工况T01、工况T02实测锅炉效率分别为93.10%、94.00%，投运热风外用系统使锅炉效率下降约0.9百分点。

Abstract

For the analysis of the heat applied to equipment outside the system boundary

the energy utilized was outside the GB/T 10184 standard

and the boiler efficiency calculation could not take advantage of the existing standard. The external heat loss of hot air was divided into two categories: hot air reuse and hot air non-reuse. Based on the GB/T 10184 calculation framework

the calculation methods of these two categories of external heat loss of hot air were proposed. Taking a 350 MW boiler as a practical example

under the same load

continuous operation of hot air external use and shutdown of hot air external use were compared. According to the actual test data and analysis results

the calculation method was used to compare the actual operating conditions. The influence of external loss of hot air on boiler efficiency was analyzed. The results showed that the test results of combustible materials in two working conditions were basically the same. The external loss of hot air in T01(cold air recovery)was 0.82%

the external loss of hot air(cold air nonrecovery) was 0.13%

and the external loss of hot air in T02 was 0. The measured boiler efficiency in T01 and T02 conditions was 93.10% and 94.00% respectively. The operation of external hot air system reduced the boiler efficiency by about 0.9 percentage point.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

Difference in boiler efficiency calculation between ASME PTC4.1—1964 and ASME PTC4—2013

Experimental study on performance of supercritical 350 MW CFB unit based on ASME PTC4 standard

CALCULATION AND ANALYSIS OF ACID DEW-POINT FOR FLUE GAS

TEST STUDY ON COMBUSTION ADJUSTMENT OF BOILER FOR SUPERCRITICAL 600MW UNIT IN YANGZHOU POWER PLANT

STUDY ON ON-LINE MONITORING SYSTEM FOR COGENERATION UNITS IN SHANDONG PROVINCE

Related Author

WANG Zhucheng

MENG Guixiang

YAO Sheng

LIU Jun

CHEN Baokang

SHI Yanzhou

WANG Zhucheng

QUAN Li

Related Institution

Xi'an Thermal Power Research Institute Co., Ltd. Suzhou Branch

Jiangsu Huamei Thermal Power Co., Ltd

North China Electric Power Research Institute

College of Energy and Power Engineering, North China Electric Power University

Power Department of Baoding Electric Power Vocational and Technical College

AI问答

⁰