基于混合卷吸机理的高温高压蒸汽引射器热力学设计与结构优化

郭宇朦; 马素霞; 张敬贤; 张嘉杰

doi:10.19666/j.rlfd.202507134

English

您当前的位置：

首页 >

文章列表页 >

基于混合卷吸机理的高温高压蒸汽引射器热力学设计与结构优化

Thermal Power Generation Vol. 55, Issue 3, Pages: 53-63(2026)

更新时间：2026-08-07

- 基于混合卷吸机理的高温高压蒸汽引射器热力学设计与结构优化
- 作者机构：
  
  1. 太原学院建筑与环境工程系
  2. 太原理工大学电气与动力工程学院
  3. 怀柔实验室山西研究院
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202507134
  CLC： TM621
- Published：2026
- 稿件说明：
移动端阅览
[1]郭宇朦,马素霞,张敬贤,等.基于混合卷吸机理的高温高压蒸汽引射器热力学设计与结构优化[J].热力发电,2026,55(03):53-63.
[1]郭宇朦,马素霞,张敬贤,等.基于混合卷吸机理的高温高压蒸汽引射器热力学设计与结构优化[J].热力发电,2026,55(03):53-63. DOI： 10.19666/j.rlfd.202507134.

DOI：10.19666/j.rlfd.202507134.

摘要

热电联产机组耦合蒸汽引射器技术能够有效实现热电联产解耦及深度电力调峰。作为系统核心部件，蒸汽引射器的性能直接影响机组运行效率和稳定性。首先针对高温高压蒸汽引射器，提出了一维热力学设计模型，该模型考虑可压缩混合层发展特点，首次基于混合卷吸机理，引入可压缩混合层厚度概念，确定引射器的径向尺寸；然后采用数值模拟分析引射器性能及流场特性，进一步优化轴向尺寸，推荐最优结构为：喷嘴距6 mm、混合室长度42 mm、扩压室角度4.4°；最后搭建实验系统验证设计方法，基于设计方法设计的引射器的引射系数与实验值的平均相对误差为6.6%，验证了设计方法的准确性。研究结果可为高温高压蒸汽引射器的结构设计提供理论指导，具有重要的工程应用价值。

Abstract

Steam ejector technology integrated into combined heat and power systems enables effective thermalelectric decoupling and deep load following

with ejector performance directly influencing overall efficiency and operational stability. A one-dimensional thermodynamic design model for high-temperature and high-pressure steam ejectors is developed by incorporating the development characteristics of the compressible mixing layer. The concept of compressible mixing layer thickness is introduced based on the entrainment mechanism to determine the radial dimensions of the ejector. Numerical simulations are performed to evaluate ejector performance and flow field characteristics

which guide the optimization of axial dimensions. The optimal structural parameters are identified as a nozzle-to-mixing chamber distance of 6 mm

a mixing chamber length of 42 mm

and a diffuser angle of 4.4°. An experimental system is constructed to validate the proposed design method

and the results show an average relative error of 6.6% between the predicted and measured entrainment ratios

demonstrating the model's accuracy. The results provide a theoretical foundation for the structural design of high-temperature and highpressure steam ejectors and hold significant potential for practical engineering applications.

关键词

Keywords

references

周天羽,张一农,徐钢,等.考虑调峰辅助服务收益的耦合储热罐热电联产机组运行调度研究[J].热力发电,2025, 54(5):92-101.ZHOU Tianyu, ZHANG Yinong, XU Gang, et al.Research on operation scheduling of cogeneration units coupled with heat storage tank considering peak shaving ancillary service income[J]. Thermal Power Generation,2025, 54(5):92-101.

夏大伟,张少锋,李玲,等.热电联产系统集成蒸汽喷射器性能分析[J].热力发电, 2024, 53(11):147-154.XIA Dawei, ZHANG Shaofeng, LI Ling, et al.Performance analysis of integrated steam injectors in cogeneration systems[J]. Thermal Power Generation,2024, 53(11):147-154.

SONG Y J, WANG C, WANG L, et al. Design criterion of critical mode ejector for PEMFC hydrogen supply and recycle system[J]. Applied Energy, 2025, 377:124566.

KEENAN J H, NEUMANN E P, LUSTWERK F. An investigation of ejector design by analysis and experiment[J]. ASME Journal of Applied Mechanics,1950, 72:299-309.

CHEN W X, LIU M, CHONG D T, et al. A 1D model to predict ejector performance at critical and sub-critical operational regimes[J]. International Journal of Refrigeration, 2013, 36(6):1750-1761.

HUANG B J, CHANG J M, WANG C P, et al. A 1-D analysis of ejector performance[J]. International Journal of Refrigeration, 1999, 22(5):354-364.

LIU F, GROLL E A. Study of ejector efficiencies in refrigeration cycles[J]. Applied Thermal Engineering,2013, 52(2):360-370.

LIU J P, WANG L, JIA L. A predictive model for the performance of the ejector in refrigeration system[J].Energy Conversion and Management, 2017, 150:269-276.

CARDEMIL J M, COLLE S. A general model for evaluation of vapor ejectors performance for application in refrigeration[J]. Energy Conversion and Management,2012, 64:79-86.

LI F L, TIAN Q, WU C Z, et al. Ejector performance prediction at critical and subcritical operational modes[J].Applied Thermal Engineering, 2017, 115:444-454.

LIU Y, YU M Q, YU J L. An improved 1-D thermodynamic modeling of small two-phase ejector for performance prediction and design[J]. Applied Thermal Engineering, 2022, 204:118006.

ZHOU Y F, CHEN G M, HAO X Y, et al. A theoretical model for performance evaluation of a novel configuration of supersonic ejectors[J]. Applied Thermal Engineering,2023, 231:120867.

牛擎宇,关欣,宋子晔,等.跨临界CO2喷射器关键结构的优化研究[J].动力工程学报, 2022, 42(6):559-567.NIU Qingyu, GUAN Xin, SONG Ziye, et al. Optimization of key structures for transcritical CO2 ejector[J]. Journal of Chinese Society of Power Engineering, 2022, 42(6):559-567.

ZHU Y H, CAI W J, WEN C Y, et al. Shock circle model for ejector performance evaluation[J]. Energy Conversion and Management, 2007, 48(9):2533-2541.

LI H, WANG X D, NING J X, et al. Numerical investigation of the nozzle expansion state and its effect on the performance of the steam ejector based on ideal gas model[J]. Applied Thermal Engineering, 2021, 199:117509.

SLESSOR M D, ZHUANG M, DIMOTAKIS P E.Turbulent shear-layer mixing:growth-rate compressibility scaling[J]. Journal of Fluid Mechanics, 2000, 414:35-45.

孙博昭,岳爽,王春波,等. 350 MW超临界机组可调式蒸汽喷射器工业供热性能数值模拟研究及试验验证[J].华北电力大学学报(自然科学版), 2021, 48(3):98-107.SUN Bozhao, YUE Shuang, WANG Chunbo, et al.Numerical simulation and test verification on industrial heating performance of adjustable steam ejector in 350MW supercritical unit[J]. Journal of North China Electric Power University(Natural Science Edition), 2021, 48(3):98-107.

PIANTHONG K, SEEHANAM W, BEHNIA M, et al.Investigation and improvement of ejector refrigeration system using computational fluid dynamics technique[J].Energy Conversion and Management, 2007, 48(9):2556-2564.

SHARIFI N. Axisymmetric and three dimensional flow modeling within thermal vapor compressors[J]. Heat and Mass Transfer, 2013, 49(10):1489-1501.

GUO Y M, ZHANG J X, MA S X, et al. Coupling optimization design of adjustable nozzle for a steam ejector[J].Applied Thermal Engineering, 2024, 252:123550.

KUMAR V, SACHDEVA G. 1-D model for finding geometry of a single phase ejector[J]. Energy, 2018, 165:75-92.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Publicity Resources

可实现的新型卡诺电池与塔式光热并联系统及其协同优化研究

压缩空气储能电站储气库内置换热器运行策略影响研究

THERMODYNAMIC ANALYSIS OF DISTRIBUTED ENERGY SYSTEM WITH MICRO-GAS-TURBINE

Thermodynamic analysis of novel advanced adiabatic compressed air energy storage system with variable pressure ratio

Economic optimization of low-temperature waste heat recovery in supercritical carbon dioxide coal-fired power system

Related Author

薛小军

汪茹康

徐钢

杜亚轩

葛士宇

邹磊

王子遇

李斌

Related Institution

华北电力大学热电生产过程污染物监测与控制北京市重点实验室

山西大学电力与建筑学院

中国电建集团中南勘测设计研究院有限公司

四川大学山区河流保护与治理全国重点实验室

Zhejiang University of Technology

AI问答

⁰