电厂除尘器入口烟道数值模拟及改造

陶克轩; 常毅君; 张波; 王晓冰; 牛国平; 卢承政; 杨恂

English

您当前的位置：

首页 >

文章列表页 >

电厂除尘器入口烟道数值模拟及改造

热力发电 2011年40卷第1期页码：52-54

发电技术论坛 | 更新时间：2025-09-28

- 电厂除尘器入口烟道数值模拟及改造
- NUMERICAL SIMULATION AND RETROFIT OF INLET FLUE DUCT FOR ELETROSTATIC PRECIPITATOR
- 作者机构：
  
  1. 华能玉环电厂
  2. 西安热工研究院有限公司
- 作者简介：
- 基金信息：
- DOI：
  中图分类号： X701.2
- 纸质出版：2011
- 稿件说明：
移动端阅览
陶克轩, 常毅君, 张波, 等. 电厂除尘器入口烟道数值模拟及改造[J]. 热力发电, 2011,40(1):52-54.

TAO Kexuani1, CHAGN Yijun1, ZHANG Bo2, et al. NUMERICAL SIMULATION AND RETROFIT OF INLET FLUE DUCT FOR ELETROSTATIC PRECIPITATOR[J]. Thermal Power Generation, 2011, 40(1): 52-54.
陶克轩, 常毅君, 张波, 等. 电厂除尘器入口烟道数值模拟及改造[J]. 热力发电, 2011,40(1):52-54. DOI：

TAO Kexuani1, CHAGN Yijun1, ZHANG Bo2, et al. NUMERICAL SIMULATION AND RETROFIT OF INLET FLUE DUCT FOR ELETROSTATIC PRECIPITATOR[J]. Thermal Power Generation, 2011, 40(1): 52-54. DOI：

摘要

通过数值模拟分析某电厂超超临界4×1 000 MW机组除尘器入口飞灰流量分布不均匀的原因

认为是由于除尘器入口结构不合理所致。为此

提出了相应改进措施:(1)在烟道分配室内安装2片导流板;(2)改造原除尘器入口结构中的3号烟道和2号烟道之间的导流板;(3)在1号烟道入口下方安装导灰板。改造后

灰量分布偏差由19%降为7%

灰量均流效果显著。

Abstract

Through Numerical Simulation

the causes leading to non-uniform distribution of fly ash at inlet of the electrostatic precipitator(EP) for ultra-supercritical 4×1000 MW untis in one power plant has been analysed

it is believed that the said situation is due to unreasonable structure of the EP's inlet.For this

retrofit measures have been put forward as follows:(1) two baffle plates have to be installed into distribution chamber of the flue duct;(2) the baffle plate between flue duct no.3 and flue duct no.2 in original structure of EP's inlets has to be retrofitted;(3) a guide plate for ash has to be installed below inlet of flue duct no.1.After retrofitting

the deviation of fly ash distribution decreases from 19% before retrofit to 7% after retrofit

the effectiveness of fly ash uniformization being remarkable.

关键词

Keywords

references

浏览量

263

下载量

CSCD

文章被引用时，请邮件提醒。

提交

关联资源

采用空冷器的火电厂主厂房多元通风降温分析

加装SCR脱硝装置的锅炉系统数值模拟

SCR反应器入口段流场均匀性的数值模拟研究

1000 MW双切圆燃煤锅炉多燃料混烧结渣特性试验与数值模拟研究

旋流对冲燃烧锅炉燃烧器偏转及托举风改造数值模拟研究