煤/气混燃锅炉再热汽温偏差调整实验

闫俊伏; 赵学斌

doi:10.19666/j.rlfd.201805153

English

您当前的位置：

首页 >

文章列表页 >

煤/气混燃锅炉再热汽温偏差调整实验

热力发电 2019年48卷第2期页码：108-113

发电技术论坛 | 更新时间：2025-09-28

- 煤/气混燃锅炉再热汽温偏差调整实验
- Experimental study on reheat steam temperature deviation adjustment for boiler co-firing coal with gases
- 作者机构：
  
  山西兴能发电有限责任公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.201805153
  中图分类号： TM621.2
- 纸质出版：2019
- 稿件说明：
移动端阅览
闫俊伏, 赵学斌. 煤/气混燃锅炉再热汽温偏差调整实验[J]. 热力发电, 2019,48(2):108-113.

YAN Junfu, ZHAO Xuebin. Experimental study on reheat steam temperature deviation adjustment for boiler co-firing coal with gases[J]. Thermal Power Generation, 2019, 48(2): 108-113.
闫俊伏, 赵学斌. 煤/气混燃锅炉再热汽温偏差调整实验[J]. 热力发电, 2019,48(2):108-113. DOI： 10.19666/j.rlfd.201805153.

YAN Junfu, ZHAO Xuebin. Experimental study on reheat steam temperature deviation adjustment for boiler co-firing coal with gases[J]. Thermal Power Generation, 2019, 48(2): 108-113. DOI： 10.19666/j.rlfd.201805153.

摘要

为了研究混燃高炉煤气对炉膛上部烟气速度偏差的影响

对不同高炉煤气热量混燃比工况进行了数值模拟

得到炉膛上部烟气速度偏差随着高炉煤气热量混燃比的增加而增大。针对混燃高炉煤气引起的再热汽温偏差问题进行了分离燃尽风水平摆角优化调整实验

得到了最佳摆角组合。结果表明:分离燃尽风(SOFA)的1号、2号、3号、4号喷口水平偏转角度依次为–7.5°、+7.5°、+7.5°、–7.5°时

再热汽温偏差由17.10℃降低到了2.55℃

再热汽温为536.4℃

主蒸汽汽温偏差为4.15℃

主蒸汽温度为538.7℃。

Abstract

In order to study the effect of co-firing blast furnace gas on flue gas velocity deviation of upper furnace

numerical simulation was carried out under conditions with different heat adding ratios of blast furnace gas. It finds that the deviation of flue gas velocity increased with the heat adding ratio of blast furnace gas.Aiming at solving the problem of reheat steam temperature deviation caused by co-firing blast furnace gas

the experiment of adjusting the horizontal yaw angles of separated overfire air was carried out

and the optimal pattern of yaw angles was obtained. The results show that

when the separated overfire air yaw angles of No.1

No.2

No.3 and No.4 nozzle were adjusted to –7.5°

+7.5°

+7.5° and –7.5°

the deviation of reheat steam temperature reduced from 17.1 ℃ to 2.55 ℃

the reheat steam temperature was 536.4 ℃

the main steam temperature deviation was 4.15 ℃

and the main steam temperature was 538.7 ℃.

关键词

Keywords

references

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

关联资源

直流锅炉给水流量测量偏差原因分析及解决措施

SCR反应器导流板及喷氨面的优化设计

DCS主蒸汽流量计算模型的改进

低温再热器磨损泄漏及再热汽温偏低原因分析及改造

可燃废气利用技术研究进展(Ⅰ):高炉煤气、转炉煤气和焦炉煤气