800H合金“异常”蠕变行为及影响研究

王庆武; 李旭; 王苗苗; 刘协文; 吕典; 詹英杰; 魏文斌; 杨鹏; 朱武军; 赵鹏; 项延训

doi:10.19666/j.rlfd.202508049

English

您当前的位置：

首页 >

文章列表页 >

800H合金“异常”蠕变行为及影响研究

热力发电 2026年55卷第4期页码：183-190

发电技术论坛 | 更新时间：2026-06-12

- 800H合金“异常”蠕变行为及影响研究
- 800H合金“异常”蠕变行为及影响研究
- 作者机构：
  
  1. 华能核能技术研究院有限公司
  2. 四川大学原子核科学技术研究所辐射物理及技术教育部重点实验室
  3. 华东理工大学机械与动力工程学院
- 作者简介：
- 基金信息：
  
  国家重点研发计划项目（2022YFB3707204）~~
- DOI：10.19666/j.rlfd.202508049
  中图分类号： TG132.3;TM623
- 纸质出版：2026
- 稿件说明：
移动端阅览
[1]王庆武,李旭,王苗苗,等.800H合金“异常”蠕变行为及影响研究[J].热力发电,2026,55(04):183-190.
[1]王庆武,李旭,王苗苗,等.800H合金“异常”蠕变行为及影响研究[J].热力发电,2026,55(04):183-190. DOI： 10.19666/j.rlfd.202508049.

DOI：10.19666/j.rlfd.202508049.

摘要

800H合金是高温气冷堆蒸汽发生器主蒸汽联箱的关键材料，在高温高压的长期服役条件下易发生蠕变损伤与失效。通过在不同温度与应力条件下进行800H合金的拉伸与蠕变试验，系统获取了其力学性能参数及蠕变曲线。结果表明，该合金在蠕变初期存在蠕变速率先减小后增大的“异常”行为，且该现象在低应力条件下更明显。通过Monkman-Grant关系与应力指数法，确定了考虑“异常”蠕变行为后的真实稳态蠕变速率。进一步研究发现，该“异常”蠕变行为显著降低了蠕变速率，并影响后续蠕变过程。通过定量分析发现，异常点蠕变速率随温度升高和应力增大而升高，异常持续时间占比则随应力增大而增加。研究结果为深入理解800H合金的蠕变行为与强化机理提供了重要依据。

Abstract

The 800H alloy is a critical high-temperature material used for the main steam header of high-temperature gas-cooled reactor steam generators and is prone to creep damage and failure under prolonged high-temperature and high-pressure service conditions. In this study

tensile and creep tests were systematically performed on 800H alloy under various temperatures and stress levels to obtain its mechanical properties and detailed creep curves. The results indicate that the alloy exhibits an anomalous creep behavior in the early stage of creep

characterized by an initial decrease followed by an increase in creep rate

which is more pronounced under lower stress conditions. The true steady-state creep rate

accounting for this anomalous behavior

was determined using the Monkman-Grant relationship in combination with stress exponent analysis. Further investigation shows that this anomalous creep behavior significantly reduces the creep rate and influences the subsequent creep process. Quantitative analysis reveals that the creep rate at the anomalous point increases with increasing temperature and stress

while the duration of the anomalous stage increases with applied stress. These findings provide valuable insights into the creep behavior and strengthening mechanisms of the 800H alloy.

关键词

Keywords

references

YVON P, LE FLEM M, CABET C, et al. Structural materials for next generation nuclear systems:Challenges and the path forward[J]. Nuclear Engineering and Design,2015, 294:161-169.

李聪,刘旭,任延杰,等.镍基多晶高温合金抗蠕变性能研究进展[J].中国材料进展, 2025, 44(4):360-372.LI Cong, LIU Xu, REN Yanjie, et al. Research progress on creep properties of Ni-Base crystalline superalloys[J].Materials China, 2025, 44(4):360-372.

MIZIA R E, CLARK D E, GLAZOFF M V, et al.Optimizing the diffusion welding process for alloy 800H:thermodynamic, diffusion modeling, and experimental work[J]. Metallurgical and Materials Transactions:A,2013, 44:154-161.

QIN H, BI Z, LI D, et al. Study of precipitation-assisted stress relaxation and creep behavior during the ageing of a nickel-iron superalloy[J]. Metallurgical and Materials Transactions:A, 2019, 742:493-500.

EPISHIN A I, LISOVENKO D S. Negative creep of single crystals of nickel-based superalloys[J]. Mechanics of Solids, 2024, 59(3):1321-1329.

FIRLUS K, VOELKL R, GABEL J, et al. The influence of Cr, Al, Co, Fe and C on negative creep of Waspaloy[J].International Journal of Materials Research, 2021, 112(2):90-97.

HAHN P, SCHWIENHEER M, KONTERMANN C, et al.Modeling of creep and stress relaxation of the nickel-base alloy NiCr20TiAl at isothermal and non-isothermal loading conditions[J]. Materials Science&Engineering Technology, 2017, 48(11):1070-1081.

PRASITTHIPAYONG A, FRAZER D, KAREER A, et al.Micro mechanical testing of candidate structural alloys for Gen-IV nuclear reactors[J]. Nuclear Materials and Energy,2018, 16:34-45.

GABB T P, DRAPER S L, HULL D R, et al. The role of interfacial dislocation networks in high temperature creep of superalloys[J]. Materials Science and Engineering:A,1989, 118:59-69.

康霞龙. 800H合金蠕变性能研究[J].装备制造技术,2015(12):217-220.KANG Xialong. Creep properties of 800H alloy[J].Equipment Manufacturing Technology, 2015(12):217-220.

盛钟琦, KATERBAU K. 800H合金长时间蠕变下的显微组织[J].核动力工程, 1993(4):361-367.SHENG Zhongqi, KATERBAU K. Microstructure of800H alloy during long-term creep[J]. Nuclear Power Engineering, 1993(4):361-367.

GAO M, XIA S, HUANG C, et al. Study of microstructure and mechanical properties of 800H alloy during creep[J].Materials, 2025, 18(4):912.

徐显强. 7050铝合金高温蠕变时效行为研究[D].南昌:南昌航空大学, 2023:1.XU Xianqiang. Study on high-temperature creep aging behavior of 7050 aluminum alloy[D]. Nanchang:Nanchang Hangkong University, 2023:1.

BHADURI A. Creep and stress rupture[M]. Singapore:Springer Singapore, 2018:1.

DAHL K V, HALD J. Negative creep in nickel base superalloys[C]//International Conference on Life Management and Maintenance for Power Plants. Helsinki,Finland, 2004:329-343.

张斌,胡正飞. 9Cr马氏体耐热钢发展及其蠕变寿命预测[J].钢铁研究学报, 2010, 22(1):26-31.ZHANG Bin, HU Zhengfei. Development of 9Cr martensitic heat-resistant steel and its creep life prediction[J]. Journal of Iron and Steel Research, 2010,22(1):26-31.

牛田野,高永建,陶贤超,等.核级SA-508 Gr.3 Cl.1材料拉伸与压缩蠕变行为的比较研究[J].机械工程学报, 2023, 59(4):96-104.NIU Tianye, GAO Yongjian, TAO Xianchao, et al.Comparative study on tensile and compressive creep behavior of nuclear-grade SA-508 Gr.3 Cl.1 material[J].Journal of Mechanical Engineering, 2023, 59(4):96-104.

BRANDON D G, ROSEN A. Quantitative relation between properties and microstructure[M]. Jerusalem:Israel Universities Press, 1969:1.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

关联资源

考虑电解槽分钟级动态特性的碱性与质子交换膜电解槽混合制氢系统容量规划

基于风光预测的氧化铝溶出绿电-熔盐协同供能系统多目标优化

基于深度强化学习的固体氧化物电解池蒸汽进汽系统多目标智能控制策略

氨氢燃烧-分解耦合体系中燃烧器结构对氮氧化物生成与分解效率的作用机理研究

基于神经网络和遗传算法的气膜冷却孔结构优化